6
Installation
Feed the speaker wire harness through the 1/2” hole.
Apply the supplied foam sealing tape to the inside of the speaker enclosure
to make sure you have a weather tight seal.
NOTE: Be sure leave adequate wire length to attach the speaker.
Attach the speaker wire harness connectors to the speaker terminals.
Install using the supplied bolt through the top of the enclosure. The bolt
will go through the drilled 5/16” hole. Secure with the supplied nut.
Finish securing the speaker pod in place with the (2) bolts used earlier.
Take the speaker wire harness and run from the RFYXZ-K8 or RFYXZ-
PMXDK harness under the hood to the holes drilled in the foot well.
