1. Mark the desired position for the vise on the bottom of your
workbench top.
2. Measure the thickness of the top at that location and determine
the longest lag screw length that will not penetrate through the top.
3. Drill four 1/4" holes as indicated on the template. Be careful not to
drill through your workbench top.
4. Temporarily clamp the vise over the pre-drilled holes and secure with
four 1/4" lag screws and washers.
Distributed by Rockler Companies, Inc.
©2015 Rockler Woodworking and Hardware
37375
Rev 11/15
Check Rockler.com for updates. If you have further questions, please contact our Technical
Support Department at 1-800-260-9663 or support@rockler.com
2
6"
5
5
⁄
8
"
3
1
⁄
2
"
11/16"
11/16"
Flush to edge of workbench
Vise Mounting Template
