Page 6 of 16
SETTING THE DELAY
On the side panel there are two 16 position rotary switches, using any standard 1/8 inch
straight blade screwdriver (or your ROCKN STOMPN screwdriver included in the poly bag with
this instruction manual), you can set the desired delay from 1 to 15 seconds. You will feel a
slight click as you rotate the rotary switches' actuator; each click represents one second. There
are no mechanical stops, so you can rotate the actuator clockwise or counterclockwise as many
times as you want without fear of damaging the switch.
Notice the triangle pointer molded into the top of the actuator next to screwdriver slot. This
triangle pointer will indicate your selected delay from 1-15 seconds, or 0 (Zero).
As a starting point and standard practice here in the shop, we like to start by first dialing in
double ( 00 ) zero. On delay set to zero . Off delay set to zero. When you turn on the rocker
switch, everything should come on all a once, all four dedicated LEDs on top should light up, all
at the same time. "Instant On Mode"
Then engage the push button switch with your thumb or foot and watch three LEDs go out all
at the same time and receptacle one LED stays on. "Receptacle One Always On Mode". Push
the pushbutton switch a couple of times,and watch the three LED's turn on and off. Then you
know for a fact you are at (00).
Now dial in the delay you want by counting the number of clicks you feel in the screwdriver as
you select your delay. As a starting point select 2 seconds for the On delay by counting the
clicks and select 4 seconds for the Off delay setting.
Notice the triangle pointer molded into the top of the actuator next to screwdriver slot, it
should be pointing at your selected delay on side panel decal . Looking at your selection for
verification is recommended.
Remember to always keep delays settings differant to avoid timer mode.
