13
3.
Remove the dips�ck from the engi
ne.
Insert the oil funnel. (Fig.26
)
Fig.26
4. Add oil slowly to bring level to full. (Fig.
27
).
5
.To check the oil level: wipe the dips�ck
with a clean rag. Insert the dips�ck i
nto
the oil fill opening without sc
rewing in.
Remove the dips�ck to check th
e oil mark.
6. Slowly add more oil and repeat step 4
un�l t
he oil mark reaches to the top of the
dips�ck (Fi
g.27
).
D
o not over fill the
crankcase. The generator is equipped with
a low oil sensor and will not start if the
amount of oil is
in sufficient.
7. Check for oil leaks. Tigh
ten dips�ck
firmly before closing the access panel.
Fig.27 Oil Fill Opening, Dips
�
ck and Oil Level
Step 2-ADD GASOLINE
DANGER:
This generator may emit highly
flammable and explosive gasoline
vapors, which can cause severe burns
or even death if ignited. A nearby open
flame can lead to explosion even if not
directly in contact with gasoline.
Use fresh (within 30 days from purchase),
lead-free gasoline with a minimum of 87
octane ra�ng. Do not mix oil with
gasoline.
To add gasoline, follow these steps:
1. Make sure the generator is on a level
surface.
2. Unscrew fuel cap and set aside.
NOTE:
The fuel cap may be �gh
t and
hard to unscrew.
3. Slowly add unleaded gasoline to the
fuel tank up to the red level.
①
Red line
②
Fuel level.
Be careful not to overfill
. The capacity of
the fuel tank is 1
US
gallon.
NOTE:
Do
not fill the fuel tank to the very top.
Gasoline will expand and spill over during
use when the fuel warms up even with the
fuel cap in place.
Fig.28
Fig.29
4. Reinstall fuel cap and wipe clean any
spilled gasoline with a dry cloth.
IMPORTANT:
• Use only unleaded gasoline. The use of
leaded gasoline will cause severe damage
to internal engine parts.
Summary of Contents for R2000i
Page 35: ...35 WIRING DIAGRAM...
