16
5. Pull the choke knob fully out.
Fig.36
WARNING:
The choke is not
required to start a warm engine. Push the
choke knob fully in.
6. Pull sl
owly on the recoil starter un�l i�s
engaged, then pull it briskly.
NOTE:
Grasp the carryin
g handle firmly
to preven
�he generator from falling over
when pulling the recoil starter.
Fig.37
7
. A�er the engine starts, warm up the
engine un�l the engine does not sto
p.
Then press push the choke knob fully in.
Fig.38
NOTE:
When star�ng the engine, with
the ESC “ON”, and there is no load o
n the
generator:
• In ambient temperature below
0
℃
(32
℉
), the engine will run at the rated
r/min (50
00r/min) for 5 minutes to warm
up the engine.
• In ambient temperature below
5
℃
(41
℉
)
, the engine will run at the
rated r/min (500
0r/min) for 3 minutes to
warm up the engine.
• The ESC unit operates normally
a�er the
above �me period, while the E
CS switch
(Black
) is “ON”.
ECO-MODE IDLE CONTROL
SWITCH
This generator is equipped with an
Eco-Mode Idle Control Switch. Engaging
the switch will automa�call
y adjust the
engine speed to match the load at hand.
When an electrical device comes on line,
the generator engine will automa�cally
speed up to supply the power needed and
will slow down as the need decreases. The
variable engine speed can reduce fuel
consump�on and noise level. Keep this
switch engaged when the power load
requirement is less than 1000W. Do not
engage the Idle Control Switch when the
total load is more than 1000W. The
generator engine must run at full speed to
supply the required power for anything
over 1000W.
STOPPING THE
GENERATOR
To Stop The Generator
1.
Turn off all electrical devices prior to
unplugging them from the generator.
NOTE:
Unplugging running devices can
cause damage to the generator.
2. Turn the ECS switch (Black
) to “OFF”.
Fig.39
Summary of Contents for R2000i
Page 35: ...35 WIRING DIAGRAM...
