21
Wire
Gauge
#12
wire
NR 300 200 150
100
#14
wire
375 200 125 100
65
#16
wire
250 125 100 50
NR
Fig.47
*NR = Not Recommended
- Maximum Extension Cord Lengths by
Power Requirement.
If an overload occurs, shut down the
generator. Unplug all electrical devices
and wait
five minutes. Then, st
art the
unit back up again to get power back.
WARNING:
• Never operate the engine in a closed
area or it may cause unconsciousness
and death within a short �me. Operate
the
engine in a well ven�lated area.
• Before star�ng the engine, do not
connect any electric devices.
CAUTION:
• The generator has been shipped without
engine oil. Do not start the engine
�ll fill
with the
sufficient engine oil.
NOTE:
Do not �lt the ge
nerator when
adding engine oil. This could result in
over
filling and damage t
o the engine.
NOTE:
The generator can be used with the rated
output load at standard atmospheric
condi�ons.
“Standard atmospheric condi�ons”
Ambient temperature 25
℃
Barometric pressure 100kPa
Rela�ve humidity 30%
The output of the generator varies due to
change temperature, al�tude (lowe
r air
pressure at higher al�tude) and h
umidity.
The output of the generator is reduced
when the temperature, the humidity and
the al�tude ar
e higher than standard
atmospheric condi�ons.
Addi�onally, the load must be reduced
when using in a confined areas, as
generator cooling is affected.
ALTERNATING CURRENT (AC)
CONNECTION
WARNING
Be sure any electric devices are turned off
before plugging them in.
CAUTION
• Be sure all electric devices including the
lines and plug connec�ons ar
e in good
condi�o
n
before connec�on to the
generator.
• Be sure the total load is within
generator rated output.
• Be sure the receptacle load current is
within receptacle rated current.
NOTE:
Make sure to grou
nd (Earth) the
generator. When the electric device is
earthed, always the generator must be
earthed.
1. Start the engine.
2. Turn the ECS switch (Black
) to “ON”.
3. Plug in to AC receptacle.
4. Make sure the AC pilot light (Green
)
is
on.
5. Turn on any electric devices.
NOTE:
The ECS switch (Black
)
must be
turned to “OFF” to increase engine speed
to rated rpm. If the generator is
connected to mul�ple loads or electricity
consumers, please
remember to first
connect the one with the highest star�ng
current, and last connect the one with the
lowest star�ng current.
Summary of Contents for R2000i
Page 35: ...35 WIRING DIAGRAM...
