Printed in GERMANY
© 2013 rockruepel Pro.Audio. All rights reserved.
2 – Safety Review
WARNING: High Voltage – Risk of electric shock
Do not open chassis.
Ensure that the correct voltage (115V/230V) is selected before connecting the
comp.two
to the main power supply.
If the device is damaged or does not work as expected, refer to qualified service staff
only.
Never use damaged power chords.
Replace fuse with the same type and value : T 1 A (115V); T 500 mA (230V)
Ensure that the
comp.two
is connected via a grounded connection.
Keep away from moisture and other liquids.
Do not use the
comp.two
close to water or in wet surroundings.
CAUTION: Temperature – Chassis may become hot during operation
Do not install any heat sources (for instance radiators or stoves) close to the device.
Avoid direct solar irradiation.
Do not block the circulation vents. Warm air must exhaust.
Leave enough free rack-spaces around the compressor to avoid overheating.
Do not install power amps near the device.
WARNING: Incorrect installation – Connection may cause damage
Do not connect power amp-outputs to the
comp.two
.
Install the device only on flat surfaces or mount it properly into an adequate rack.
WARNING: Condensed water (liquid) may cause damage
Condensation inside the device may occur, when you move the device from a cold
place to a warm room. To avoid damaging the
comp.two
, always wait until the
device has reached room temperature before switching it on.
WARNING: High sound volume may harm the sense of hearing
This device produces a maximum amplification of 32 dB. Set input and output
controls on zero position before monitoring the sound via headphones or
loudspeakers.
Gradually increase the volume levels for input and output.
HINT: Delayed operation
The
comp.two
uses vacuum tubes, therefore the device will be on standby for
several seconds after switching it on.
