7
INSTRUCTIONS FOR USE
•
Before the first use, check the effectiveness of the safety valve. Pour 1.5 l of water
into the sprayer, screw the head back on, pump the pressure until the safety valve
is activated. The valve will go up and you will hear air leaking through it. Check for
leaks. Lift the safety valve and, holding it, release the pressure from the tank (mon 5
sec). Then unscrew the head and pour out the water.
•
Pour the right amount of the correct agent into the tank. Inflate the pressure
(approximately 15-20 strokes of the sprayer rod). Aim the nozzle at the correct
surface to be cleaned or sprayed. Press the washer button and start working. If you
do not press the button, the valve stops the flow of refrigerant.
•
After finishing work, release the pressure from the sprayer. If there is any refrigerant
left in the tank, pour it into the original tank or dilute it with water and use it until the
end of the job. The sprayer should be washed and dried after each work. Chemicals
cannot be stored in it.
OK-08.5000
SOLVENT
pressure
sprayer
The sprayer is not intended for contact with glycol-based brake fluids,
organic acids with small molecular mass (formic acid, concentrated
acetic acid), chloroacetic acid, chlorosulfonic acid, esters, aldehydes,
ketones, ethers, amines, concentrated solutions of sodium and
potassium hydroxide, paint solvents, ammonia, methanol, Cellosolve
type solvents (such as 2-ethoxyethanol), or nitro solvents which contain
acetone and toluene. The availability of various chemical agents on
the market requires the user to test the sprayer with the target agent.
KWAZAR CORPORATION Sp. z o.o. does not guarantee the universality
of the device.
OK-08.5001
ACID
pressure
sprayer
The sprayer is not intended for contact with glycol-based brake fluids,
organic acids with small molecular mass (formic acid, concentrated
acetic acid), chloroacetic acid, chlorosulfonic acid, esters, aldehydes,
keto-nes, ethers, amines, concentrated solutions of sodium and
potassium hydroxide, paint solvents, ammonia, methanol, Cellosolve
type solvents (such as 2-ethoxyethanol), or nitro solvents which contain
acetone and toluene. The availability of various chemical agents on
the market requires the user to test the sprayer with the target agent.
KWAZAR CORPORATION Sp. z o.o. does not guarantee the universality
of the device.
OK-08.5002
ALKALINE
pressure
sprayer
The sprayer is not intended for contact with mineral oils and greases,
gasoline, aliphatic and aromatic (e.g. toluene, xylene) and chlorinated
hydrocarbons, concentrated organic and inorganic acids, fats, NITRO
solvent. The availability of various chemical agents on the market
requires the user to test the sprayer with the target agent. KWAZAR
CORPORATION Sp. z o.o. does not guarantee the universality of the
device.
Summary of Contents for OK-08.5000
Page 10: ......
