25
Inner Shaft and Sealhead Removal
Remove and discard the top cap assembly.
Set the upper post aside on a clean shop towel.
Spray the inner shaft and RockShox 3-hole vise blocks with RockShox
Suspension Cleaner or isopropyl alcohol and wipe them with a clean
shop towel. The clamping surfaces must be free of oil and grease.
Clamp the inner shaft assembly into the 10 mm slot in the RockShox
3-hole vise blocks.
Unthread and remove the baseplate and Vent Valve rod assembly from
the inner shaft.
Remove the inner shaft assembly from the vise and set it aside on a
clean shop towel.
Clean the baseplate and Vent Valve rod assembly. Set the Vent Valve
rod assembly aside on a clean towel.
NOTICE
The baseplate and Vent Valve rod assembly do not require service;
do not disassemble.
6
7
RockShox 3-hole Vise Blocks
11 mm
8