31
Upper Post Disassembly
Remove the internal floating piston (IFP) from the upper post. Insert
seven to nine plastic cable ties (cable tie size may vary), one at a time,
into the upper post and through the center of the IFP.
Pull the cable ties out of the upper post and remove the IFP.
Discard the IFP
.
Remove the upper post from the vise and pour any remaining hydraulic
fluid into an oil pan or container.
With the electronics compartment positioned outside the edge of
the vise clamps, clamp the seatpost head into a bench vise with flat
aluminum soft jaw vise inserts on the flat saddle clamp slots.
NOTICE
To avoid permanent damage to the electronic components, clamp
only the flat surfaces
of the circular saddle clamp slot in the seatpost
head.
3
Plastic cable ties
4
5