31
Shock Assembly and Bleed
Allow air bubbles to escape from the bleed port in the seal head.
Allow air bubbles to escape from the bleed port in the seal head.
Insert the new compression ball into the bleed port.
Insert the new compression ball into the bleed port.
Thread the bleed screw into the bleed port until you feel it touch the
Thread the bleed screw into the bleed port until you feel it touch the
compression ball, then tighten the bleed screw an additional ½ turn.
compression ball, then tighten the bleed screw an additional ½ turn.
NOTICE
Overtightening the bleed screw can damage the compression ball.
Apply a thin layer of grease to the IFP reservoir cap o-ring. Push the IFP
Apply a thin layer of grease to the IFP reservoir cap o-ring. Push the IFP
reservoir cap into the IFP reservoir until the retaining ring groove
reservoir cap into the IFP reservoir until the retaining ring groove
is visible.
is visible.
13
14
2 mm
15