30
Shock Assembly and Bleed
Tighten the seal head/air piston.
Tighten the seal head/air piston.
NOTICE
To prevent damage to the damper body, do not allow the wrench to
slip from the seal head/air piston.
NOTICE
Make sure the shock stays fully extended throughout the bleed
process.
Squeeze the trigger on the RockShox Clamp Tool to release the clamp
Squeeze the trigger on the RockShox Clamp Tool to release the clamp
and open it fully.
and open it fully.
Place the clamp on the shock, with the RockShox IFP portion of the
Place the clamp on the shock, with the RockShox IFP portion of the
clamp tool inserted gently into the reservoir. Squeeze the large black
clamp tool inserted gently into the reservoir. Squeeze the large black
lever until the base of the tool is clamped on top of the reservoir.
lever until the base of the tool is clamped on top of the reservoir.
Squeeze the large lever until the IFP Bleed Tool pushes the IFP to
Squeeze the large lever until the IFP Bleed Tool pushes the IFP to
33 mm.
33 mm.
NOTICE
Apply upward pressure to the QuickGrip/Bleed clamp when setting
the IFP to prevent putting pressure on the eyelet.
Oil will bubble out of the bleed port as the IFP is set. This means the
Oil will bubble out of the bleed port as the IFP is set. This means the
system is bled.
system is bled.
34 mm
28 N
·
m
(250 in-lb
11
12
RockShox Clamp Tool
Trigger
RockShox Clamp Tool
RockShox Clamp Tool
RockShox Clamp Tool
33 mm
