Rocktron Valve Charger, Instruction Manual

Do not block any ventilation openings (if applicable).  Install in accordance with the 

manufacturer’s instructions.

Do not install near any heat sources such as radiators, heat registers, stoves or other ap-

paratus (including amplifiers) that produce heat.  

This product is not equipped with a plug or cable.  This pedal runs on a 9 Volt Battery, if a  

9Volt DC adapter is the used please follow adapter manufacturer’s operation instructions.

Only used attachments/accessories specified by the manufacturer.

Do not use this product with any case, stand tripod, bracket or table that is not specified by 

the manufacturer.  Insure that the case, stand, tripod, bracket etc. is properly adjusted and 

setup (follow all instructions).  Extra care and caution should be taken to avoid tip over 

and injury.

Unplug this apparatus during lightening storms or when unused during long periods of time.

Refer all service to qualified service personnel.  Servicing is required when the apparatus 

has been damaged in any way, such as power supply or plug is damaged, liquid has been 

spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain 

or moisture, does not operate normally or has been dropped.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT.  QUALIFIED PERSONNEL 

SHOULD SERVICE THIS EQUIPMENT ONLY.  DO NOT MAKE ANY INTERNAL 

ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME OR TAMPER 

WITH INTERNAL ELECTRONIC COMPONENTS AT ANY TIME.  FAILURE TO FOL-

LOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT 

AS WELL AS CAUSING A SHOCK HAZARD.

OPERATING TEMPERATURE

Do not expose this unit to excessive heat.  This unit is designed to operate between 32 F and 

104 F (0 C and 40 C).  This unit may not function properly under extreme temperatures.

Precautions