10
Compact I/O DeviceNet Scanner Module
Publication 1769-IN060C-EN-P - May 2002
7.
Attach an end cap terminator (F) to the last module in the system by using
the tongue-and-groove slots as before.
8.
Lock the end cap bus terminator (G).
System Mounting
Minimum Spacing
Maintain spacing from
enclosure walls,
wireways, adjacent
equipment, etc. Allow 50
mm (2 in.) of space on all
sides for adequate
ventilation, as shown:
Allow at least 110 mm
(4.33 in.) of enclosure depth to accommodate the module and the DeviceNet
connector.
Panel Mounting
Mount the module to a panel using two screws per module. Use M4 or #8 panhead
screws. Mounting screws are required on every module.
IMPORTANT
A 1769-ECR or 1769-ECL right or left end cap must be used to
terminate the end of the serial communication bus.
ATTENTION
!
During panel or DIN rail mounting of all devices, be sure that
all debris (metal chips, wire strands, etc.) is kept from falling
into the module. Debris that falls into the module could cause
damage on power up.
Top
Side
Bottom
Side
Controller
Compac
t I/
O
Compac
t I/
O
Compac
t I/
O
Compac
t I/
O
Compac
t I/
O
End Cap or
Cabl
e
