Publication 2711-IN021B-EN-P - July 2003
2
PN 41061-173-01(2)
Copyright © 2003 Rockwell Automation, Inc. All rights reserved. Printed in the U.S.A.
To remove and install power terminal block:
ATTENTION
!
Disconnect all power before removing or installing
components. Failure to disconnect power may result
in electrical shock and/or damage to the terminal.
1. Insert tip of small,
flat-blade, screw driver into
terminal block access slot.
2. Gently pry terminal block
away from terminal to release
locking mechanism
To remove terminal block:
1. Press terminal block base in
first with block leaning outward.
2. Genty push top of terminal block back to
vertical position to snap in locking tab.
To install terminal block:
1. Insert tip of small,
flat-blade, screw driver into
terminal block access slot.
2. Gently pry terminal block
away from terminal to release
locking mechanism
To remove terminal block:
1. Press terminal block base in
first with block leaning outward.
To install terminal block:
2. Genty push top of terminal block back to
vertical position to snap in locking tab.
PanelView Plus 400 - 600 Terminals
PanelView 300 Micro & 600 Touch Only
The location of the power terminal block on
the PV600 Touch terminal is different
but the procedure for removing and
installing the terminal block is the same.
