Publication 900-UM007D-EN-E - January 2011
5-82
Parameter Functions & Definitions
Cold Junction Compensation Method
Conditions of Use:
The Input Type must be thermocouple or non-contact
infrared temperature sensor.
Function:
This parameter allows you to specify whether cold junction
compensation is to be performed internally by the controller or to be
performed externally when the Input Type setting value is 5 to 22, 24, or 25.
The cold junction compensation external setting is valid when the temperature
difference is measured using two thermocouples or two non-contact sensors.
Related Parameter
•
Input Type (Initial Setting function group, page 5-50)
MB Command Logic Switching
Note:
Although this parameter is available, it is not used by the 900-TC8,
900-TC16, or 900-TC32 controller or configuration software. The
default is OFF and should remain unchanged.
PV Color Change
Function:
The PV Color Change function allows you to change the color of
the PV display (No. 1 display) based upon preset conditions defined in Table
5.CW.
There are three display colors (orange, red, and green) that you can select
based on the following three modes listed below and eight settings shown in
Table 5.CW.
Table 5.CV
Selections
Default Selection
on
: Internally
off
: Externally
on
cGc
rlrv
colr
Summary of Contents for Allen-Bradley 900-TC16
