504
Rockwell Automation Publication 193-UM015D-EN-P - February 2015
Appendix C
EtherNet/IP Information
Identity Object — CLASS CODE 0x0001
The following three instances of the Identity Object are supported:
Table 522 - Identity Object Instances
The following class attributes are supported for the Identity Object:
Table 523 - Identity Object Class Attributes
Instance 1 of the Identity Object contains the following attributes:
Table 524 - Identity Object Instance 1 Attributes
Instance
Name
Revision Attribute
1
Operating System Flash
The firmware rev of the Control firmware stored in flash memory
2
Boot code Flash
The firmware rev of the Boot Code stored in flash memory
3
Sensing Module
The firmware rev of the Sensing Module firmware
Attribute ID
Access Rule
Name
Data Type
Value
1
Get
Revision
UINT
1
Attribute ID
Access Rule
Name
Data Type
Value
1
Get
Vendor
UINT
1 = Allen-Bradley
2
Get
Device Type
UINT
3
3
Get
Product Code
UINT
651
4
Get
Revision
Major Revision
Minor Revision
Structure of:
USINT
USINT
Firmware revision of the Control firmware
5
Get
Status
WORD
Bit 0 – 0=not owned; 1=owned by master
Bit 2 – 0=Factory Defaulted; 1=Configured
Bits 4-7 – Extended Status (see
Bit 8 – Minor Recoverable fault
Bit 9 – Minor Unrecoverable fault
Bit 10 – Major Recoverable fault
Bit 11 – Major Unrecoverable fault
6
Get
Serial Number
UDINT
unique number for each device
7
Get
Product Name
String Length
ASCII String
Structure of:
USINT
STRING
“193-EIO Application”
8
Get
State
USINT
See CIP Common Spec
9
Get
Configuration
Consistency Value
UINT
16 bit CRC or checksum of all data included in the
following data sets:
Parameter included in the configuration assembly
MCC Object configuration data
DeviceLogix program data
Base Energy Object attribute 16
Summary of Contents for Allen-Bradley E300
