36
Rockwell Automation Publication 6200-UM001C-EN-P - July 2018
Chapter 4
Operate the Thin Client or Computer
3. Install power to the power input of the thin client or computer.
AC powered models: See
for how to
install an AC-to-DC power adapter to the DC power input on the thin
client or computer.
DC powered models: See
for how to
install DC power to the DC power input on the thin client or computer.
4. Apply power to the thin client or computer.
5. Press the power switch on the thin client or computer.
See Hardware Features on
for the power switch
location.
The thin client or industrial computer performs certain actions when it is
started or reset. See
Restart the Thin Client or Computer on page 36
for what
is done.
If your system does not start or you notice other anomalies, refer to
Restart the Thin Client or
Computer
Use any of the following methods to restart the thin client or computer.
• From the Start menu, choose Restart.
• Press Ctrl+Alt+Delete on an attached keyboard and click Restart.
During a restart, the thin client or computer does the following:
• Clears the RAM.
• Starts the POST.
• Initializes peripheral devices such as drives and printers.
• Loads the operating system (except for VersaView ThinManager® thin
client computers).
If a display is available, use it to view the progress of the POST, the initialization of
accessory devices, and the startup dialogs for any operating system that is installed.
Shut Down the Thin Client or
Computer
Use either of the following methods to shut down the thin client or computer.
Method
Actions
Windows OS
IMPORTANT:
Applies only to VersaView 5400 integrated display industrial
computers.
With an attached mouse and keyboard, do one of the following.
• Press Ctrl+Alt+Delete and click Shut Down.
• From the Start menu, click or choose Shut Down.
Power switch
Momentarily press the power switch to shut down the thin client or computer. See
Hardware Features on
