22
MP-Series Low Inertia Servo Motor Installation Instructions
Publication MP-IN002C-EN-P - April 2009
Accessory Kits
Factory available accessories for MP-Series low-inertia motors are described below.
Motor Cables
Factory manufactured feedback and power cables are available in standard cable
lengths. They provide environmental sealing up to and including an IP66 rating and
proper shield termination. For a complete listing of available cables refer to your
drive manual, contact your nearest Rockwell Automation sales office, or access the
information from the references in
Additional Resources
.
Refer to the Kinetix Motion Control Selection Guide, publication
GMC-SG001
, for
information on feedback, power, and brake cables or connector kits.
Shaft Seals
A shaft seal provides a barrier to moisture and particle entering the motor bearings.
Catalog numbers and dimensions for replacement Nitrile shaft seals are listed in the
table.
Refer to the Shaft-seal Kit Installation Instructions, publication
2090-IN012
, for
instructions on how to install a shaft seal.
Motor Cat.
No.
Inside Diameter
Outside Diameter
Width
mm (in.)
mm (in.)
mm (in.)
MPL-B640,
MPL-B660,
MPL-B680
MPL-SST-A6B6
40 (1.57)
90 (3.54)
8 (0.315)
MPL-B860,
MPL-B880
MPL-SST-A8B8
45 (1.77)
75 (2.95)
8 (0.315)
MPL-B960,
MPL-B980
MPL-SST-A9B9
52 (2.05)
72 (2.83)
8 (0.315)
IMPORTANT
Shaft seals must be lubricated. Lubricant is supplied with shaft seal kits.