PowerFlex Digital DC Drive User Manual -
Publication 20P-UM001C-EN-P - July 2008
2-6
Drive Start Up
6.
Load the Default Settings:
It is recommended that you reset the drive to the default settings. By
resetting the drive to the default settings, any previous parameter
modifications you have made will be overwritten.
1. On the HIM, from the “Main” menu scroll to the “Memory
Storage” menu and press Enter.
2. Scroll to “Reset To Defaults” and press Enter. A message displays
to verify that you want to reset the drive to the factory settings.
3. Press Enter.
Note: A “Params Defaulted” (F48) entry will be made in the drive’s
Fault Queue to indicate the change.
7.
Configure the Most Commonly Used Parameters:
If your application only requires basic drive parameter set up, you can
use the S.M.A.R.T. list screen available on the HIM to program the
drive. Refer to
Using the S.M.A.R.T. List Screen on page B-2
for more
information.
Important: In order to access all parameters in this procedure you must
set the Parameter View option to “Advanced”.
1. At the Main menu, scroll to the Parameter option and press the ALT
and then Sel button.
2. Scroll to the Numbered List option and press Enter.
3. Type 211 and press Enter.
4. Press the Sel button.
5. Type 1 and press Enter.
6. Press the Esc button.
7. Press the ALT and then Sel button.
8. Scroll to the File-Group-Par option and press Enter.
9. Scroll to the “Motor Control” file and press Enter.
