Rockwell RD3110K.1, Manual

13

130W MINI DRILL  

 EN

USING ACCESSORIES

The chart below lists the description, use speed and scope for some of the small articles supplied together with 

the tool by category. To achieve best performance of the tool, it is strongly recommended that you read it prior to 

operation, failure to adhere to this may cause accessories to fail.

NOTE:

 ALWAYS Wear eye protection Insert the shaft FULLY into the collet. Use ONLY up to the speeds stated 

below.

PICTURE

DESCRIPTION

SPEED 

FOR USE ON

Grinder bits

Various head styles,

on shafts

Full speed

Metal

Mild steel

Diamond Bits

Various head styles

Full speed

Wood    Zinc

Plastic    Nickel

Copper    Mild steel

Wool  Wheel

Mounted to screw drill

Half speed

Metal

Mild steel

Sanding/Cutting wheels

Mounted to cutting wheel 

fixture

NOTE:

DO NOT over tighten screw

Half speed

Metal

Mild steel

Wood

Sanding Roll

Mounted on hold for rubber 

wheel

Full speed

Metal

Mild steel

NOTE:

To fit the sanding roll, firstly loosen the small screw on top of the hole for rubber 

wheel, this will allow the rubber to relax. Slide the sanding roll onto the holder.

To secure, simply tighten the screw and the rubber roll will swell, gripping the sanding 

drum.