Rockwell ShopSeries RS4002, Manual

Palm SandeR 

 en

6

indicated on the rating plate.

9.  Your tool is double insulated for additional 

protection against a possible electrical insulation 
failure within the tool.

10. Always check walls, floors and ceilings to avoid 

hidden power cables and pipes.

11.  After long working periods external metal parts 

and accessories could be hot.

12. If possible, ensure the work-piece is firmly 

clamped to prevent movement.

13. Your sander is a hand held tool, do not clamp your 

sander.

14. Before sanding, check the area is free of nails, 

screws, etc.

15. Never stop the sander by applying a force to the 

base plate.

16. Only use paper in good condition. do not use torn 

or worn paper.

17.  do not sand material containing asbestos due to a 

health risk.

18. do not sand lead based paint due to the risk of 

lead poisoning.

19. do not eat or drink in the working area of the 

sander.

20. do not allow people to enter the working area 

without wearing a dust mask.

21. Where possible, seal off the working area to 

contain the dust for later removal.

22. Your tool is designed for dry sanding only, not wet 

sanding.

23. Your tool is designed for general purpose light 

polishing of wood and metals.

24. do not sand magnesium material due to the risk of 

fire.

waRnIng: Some dust particles created by 

power sanding, contain chemicals known to 

cause cancer, birth defects or other reproductive 

harm. Some examples of these chemicals are:

•  Lead from lead-based paints.
•  Crystalline silica from bricks and cement and 

other masonry products.

•  Arsenic and chromium from chemically treated 

lumber.

Your risk from these exposures varies, depending 
upon how often you do this type of work.   
To reduce your exposure to these chemicals: 
•  Work in a well-ventilated area.
•    Work with approved safety equipment, such as 

those dust masks that are specially designed to 
filter microscopic particles.

SymbOlS

To reduce the risk of injury, user must read  

in struction manual

 Warning

Wear ear protection

Wear eye protection

Wear dust mask

double insulation

   RCM approval mark

TeCHnICal  daTa

Voltage
Power input
No load speed
dimension of base
Orbital diameter
Protection class
Machine weight

230-240 V~50Hz

130W

12000/min

140x140x100mm

1mm

/II

0.93kg

OPeRaTIng InSTRuCTIOnS

nOTe:

 Before using the tool, read the 

instruction book carefully.

1. fITTIng THe SandIng PaPeR (See fig. a)

Fit the paper over the pad so that it covers the entire 
area. Make sure the sanding paper is even with the 
edges and that the dust collection holes in the pad 
and sanding paper is aligned and the sanding paper