2
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
SPECIFICATIONS
• Three modes: 12-volt/2 Amp, 12-volt/10 Amp and 12-volt/50 Amp engine start.
• Lead-Acid/Gel-cell and AGM (absorbed glass mat) battery type settings.
• Built-in meter Ammeter displays charge level in amps.
• Heavy-duty transformer and rectifi er.
• Built-in Circuit Overload protection.
• Automatic Reverse Polarity detection
(requires a minimum of 4 volts DC at the battery terminals)
• Heavy-duty cables and clamps are corrosion-resistant for better connections.
• Connect to side-or top-mount battery terminals.
• Ideal for charging or boosting during winter season when the starting performance
of vehicle batteries is lowered by cold or extreme weather conditions.
• Minimum battery voltage for charger to operate = 2.5 volts.
• Input power requirements = 120 V AC, 60 Hz., 310 Watts.
The
Rockwood 2/10/50 Amp Battery Charger/Starter
is designed with the most current
intelligent switching circuitry and technology to safely keep 12 volt automotive, marine, motorcycle,
lawn equipment and powersports batteries at peak power and effi ciency. It is fully automatic with
reverse polarity protection and is switchable for use on standard Lead/Acid, AGM and Gel type
batteries as well as offering a choice of 2 Amp or 10 Amp Charging. In addition, the Starting feature
will deliver up to 50 Amps of engine staring power.
READ INSTRUCTIONS!
Thoroughly read and understand manual before using the 20/10/50 Amp Battery
Charger/Starter. Save for future reference.
SAFETY INFORMATION
WARNING!
•
Use the Battery Charger for charging 12-volt regular, deep-cycle, sealed Lead-Acid,
Gel-cell and AGM (absorbed glass mat) batteries only. It is not intended to supply
power to a low-voltage electrical system other than in an automotive application.
• Perform all charging procedures in a safe, dry, well-ventilated area. Batteries
produce explosive gases during charging.
• Keep Battery Charger out of reach of children.
• Do not operate this Battery Charger in rain or snow, or allow it to be immersed in
water or other liquid.
• Do not open the Battery Charger. There are no user-serviceable parts inside.