6
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
CLEAN-UP
• Disconnect air supply to gun.
• Remove Paint Cup and pour unused coating into proper container.
• Wipe out any excess coating then thoroughly rinse the Paint Cup with a mild solvent compatible
with the coating being used.
• Attach the Paint Cup to the Paint Gun. Then pour a small amount of a solvent compatible with
the paint being used into the Paint Cup. Then reconnect air supply and spray solvent through
HVLP Gun in a safe area until it flows clear.
NOTE:
as an alternative, #12846Z Eastwood
Aerosol Injected Gun Cleaner is excellent for this purpose.
• Remove air supply from HVLP Gun.
• Pour out any unused solvent and remove paint cup.
• Allow solvent to dry completely from all components.
DISASSEMBLY FOR ADDITIONAL CLEANING
• Remove Air Cap by unthreading Retaining Ring.
• Remove Nozzle with wrench (included).
• Unthread and remove Fluid Control Knob from rear of Paint Gun body.
• Carefully remove Tension Coil Spring with Bushing and Needle by firmly gripping rear of
Needle and pulling out through rear of Paint Gun body.
• Inspect and clean as required.
• Replace Needle by sliding into bore in rear of Paint Gun body until it seats.
• Slide Needle Tension Spring w/bushing over the rear of the Needle.
• Replace Nozzle by threading into front of Gun Body and tighten firmly with included wrench.
CAUTION:
do not-over tighten.
• Replace Air cap by threading onto Gun Body. Make sure the air horns of the Air Cap are
oriented properly.
