24
24
62193
68193
62192
Please note! To achieve proper mounting of the
enclosed etched labels will you please follow the-
se instructions:
As delivered the etched label surface is completely
covered with paint. To make the metal numbers
and letters visible the paint must be removed
from the actual letter and numeral surfaces: this
is done as follows:
1.
Before removing the labels from the etched
frame place them with their backs on a �rm and completely level surface.
2.
Remove the paint from the surface of the characters carefully either with the ROCO rubber (art. no.
10002) a sharp knife having a straight edge or similar
object (e.g. single-edge razor blade). Take care that while doing this the paint surface between the
characters is not damaged.
3.
If the result is not satisfactory it is recommended that the remaining paint is removed with a suitab-
le paint remover. Thoroughly dry the labels and then
reapply fresh paint. Repeat the removal of the paint from the surface of the characters after the new
paint is completely dry.
4.
Carefully extract the di�erent labels from their etching frames and remove any remaining burrs.
5.
Attach the etched labels with very small amounts of adhesive on top of the printed signs on the
vehicle.
Working with etched Labels
Cement
24
8062192920.indd 24
23.04.2012 08:12:15
