Rocstor®
Rocsecure® DE51
[9]
MINIMUM SYSTEM REQUIREMENTS
To utilize the RAID, the minimum system configuration in the host computer requires the following:
3.5 or 2.5 inch SATA-compatible hard drive and/or 2.5-inch Solid State Drive(s) (SSD) are required for
the RAID System. Once the hard drive and/or SSD are formatted, the actual available storage
capacity can vary depending on the selected operating environment (normally 5-10 % less).
HARDWARE REQUIREMENTS AND PRECAUSIONS
1.
Whenever turning off or unplugging the Rocsecure DE51 Series from your computer system becomes
necessary, always remember to safely remove it from your operating system first.
2.
When the Rocsecure DE51 is connected to the computer system, it’s prohibited to remove, insert or
swap the hard drive while data transfer is being performed.
3.
If you will be incorporating either software or hardware RAID functionality to operate with the ST4
Series, it is important to understand the RAID level and its component that will be incorporated and
the precautions to take as each RAID level and component may function differently and contains
various limitations.
4.
If installing your own HDD, please make sure that the hard drives are free from bad blocks or defects
prior to installation in order to avoid system crashes or data loss.
5.
It is highly recommended for users to back up important data contained within the drives of the
Rocsecure DE51 Series on a regular basis or whenever the user feels necessary to a remote or a
separate storage device. Rocstor will not be responsible for any loss of data caused during the use of
the DE51 Series or the recovery of the data lost.
OS Independent
Windows: 2008, 2012 (32/64bit), 7, 8, 10 or higher
Linux: Red Hat, SUSE, CentOS…etc
MAC: OS X(10.6, 10.7, 10.8, 10.9 or higher)
