16
RODIA
®
350 RS SERIES
GB
Saw head
The saw head is constructed of cast alloy
components . The height adjustment of the
saw head is kept in balance by a spring .
A handle secures the saw head at the
desired height .
Saw cover
The blade guard is a stainless steel plate
cap with a removable blade cover which
is fastened by 3 knobs .
Saw spindle
The motor flange is mounted on the saw
spindle . The saw flange is to be mounted
on the saw spindle with a hexagon nut
to clamp the saw blade . (
Attention: Left-
handed screw thread.)
Saw table
The cutting table is constructed of
removable aluminum components for
easy maintenance, and a stainless steel
adjustable side stop .
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade . A drain hole, with a plug, is
located in the water container . The mud
flaps prevent most of the water mist and
make sure most water flows back in the
water container .
UNPACKING AND SET UP
Setting up
• Unpack the sawing machine and
inspect for any damaged parts .
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs .
• Level the sawing machine by adjusting
the legs in the sockets and make sure
it is stable .
Saw head
• Unscrew the transportation lock .
• By loosening the handle the saw
head can be positioned at the desired
height .
ATTENTION! The saw head is
tightened by a spring and may
accidentally jump up when the
handle is loosened.
• For 45° Jolly sawing the upper frame
with the saw head can be tilted at a
45° angle . By loosening the 2 handles
at the front and back of the machine,
the upper frame can be tilted until the
end of the factory predefined 45°
angle .
