20
RODIA
®
350 RS SERIES
GB
Cutting out of
alignment .
Machine is not leveled out .
Unstable working surface .
Improper or glazed diamond
blade .
Loosen the screws for the legs .
Pick up the machine a little bit
on one end . Let the machine
down again and tighten screws .
Perform the same procedure
on the other end . The machine
should now be leveled out .
Make sure the machine is placed
on a leveled surface .
Replace or dress the diamond
blade .
DECLARATION OF
CONFORMITY
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization
documents:
EN-55014-1, EN-IEC- 61000-3-2:2014,
EN-IEC- 61000-6-2, EN-ISO 11204,
EN-ISO 3744, NEN-EN-ISO 12100,
EN-IEC 60204-1, ISO 5349-2 .
Conforms to the following standards or
normative documents 2006/42/EG,
2014/30/EU, 2014/35/EU .
Subject to change without notice .
R .G .W . van den Boogaart
General Manager
Zevenbergen, January 2017
For spare parts or advice contact
Rodiam b .v .
Munterij 8
NL - 4762 AH Zevenbergen
+31 (0)168 331 320
info@rodiam .nl
