DM2.6 User Manual
2019-04-04 | Copyright © 2019 ROE Visual Co., Ltd. All Rights Reserved.
36
/
37
11.6 Replacing the Receiving Card
Step 1: Unlock four safety locks and open the power box housing
Step 2: Unscrew four CM2x10mm screws and take down the hub board. The receiving card is fixed
at the back of the hub board.
Step 3: Unscrew one PWM2x4mm screw and take down the receiving card.
Step4: Take a new receiving card, place it back and tighten it
Step 5: Place back the hub board and tighten it.
Step 6: Place back the power box housing and lock four safety locks.