Roebuck RB3340 Operator'S Manual Download

Page: 3 / 16

1.Technical Data

Model

Blows per minute Bore & stroke

Dimension

LxWxH

Air Consumption

Average

Weight

Inner Hose Dia.

Air Inlet

Sound pressure

Sound power

Vibrations

min-1

[inch]

[mm]

[inch]

[mm]

[Nl/s]

[SCFM]

[kg]

[lb]

[inch]

[mm]

[inch]

[dB(A)]

[m/s²] [m/s²]

max. pressure 6.3bar(90psi)

:Vibration level,

Uncertainty ;

Sound pressure dB(A),

= 3 dB Uncertainty.

Declaration of noise and vibration statement

(ISO 15744 and ISO 28927-10)

All values are current as of the date of this publication. For the latest information please visit www.roebuck-tools.com.

These declared values were obtained by laboratory type testing in accordance with the stated standards and are suitable for comparison with the declared

values of other tools tested in accordance with the same standards. These declared values are not adequate for use in risk assessments and values measured

in individual work places may be higher. The actual exposure values and risk of harm experienced by an individual user are unique and depend upon the way

the user works, the workpiece and the workstation design, as well upon the exposure time and the physical condition of the user. We, BRAMMER PLC, cannot

be held liable for the consequences of using the declared values, instead of values reflecting the actual exposure, in an individual risk assessment in a work

place situation over which we have no control. This tool may cause hand-arm vibration syndrome if its use is not adequately managed. An EU guide to managing

hand-arm vibration can be found at www. pneurop.eu/uploads/documents/pdf/PN3-02-NV_Declaration_info_sheet_0111.pdf. We recommend a programme of

health surveillance to detect early symptoms which may relate to noise or vibration exposure, so that management procedures can be modified to help prevent

future impairment.

2. Machine type(s)

• This product is designed for removing material using a chisel or suitable needles. No other use permitted. For professional use only.

• Please read the instructions carefully before starting the machine.

3. Operation

• Fix the accessories properly to the tool.

• Connect device as shown in Fig. 01.

• To start the machine, pull the trigger (A). Machine speed is increase by increasing pressure on the trigger. Release the trigger to stop.

4. Lubrication

• Use an air line lubricator with SAE #10 oil, adjusted to two drops per minute. If an air line lubricator cannot be used, add air motor oil to the inlet once a day.

5. Maintenance instruction

• Follow local country environmental regulations for safe handling and disposal of all components.

• Maintenance and repair work must be carried out by qualified personnel using only original spare parts. Contact the manufacturer or your nearest authorised

dealer for advice on technical service or if you require spare parts.

• Always ensure that the machine is disconnected from energy source to avoid accidental operation.

• Disassemble and inspect the tool every three 3 months if the tool is used every day. Replace damaged or worn parts.

• High wear parts are underlined in the parts list.

6. Disposal

• The disposal of this equipment must follow the legislation of the respective country.

• All damaged, badly worn or improperly functioning devices MUST BE TAKEN OUT OF OPERATION.

• Repair only by technical maintenance staff.

7. EC Declaration of conformity

We :

CHICAGO PNEUMATIC Tool Co. LLC 1800 Overview Drive Rock Hill, SC 29730 - USA

Machine type(s):