GuardCom Installation Manual
guardcom_installation_manual_v1.0.docm
Publicly available
p. 9 of 31
Follow these guidelines to install the DS Standalone:
Step Instruction and illustration
1.
The DS Standalone must be centered in relation to the rolls of the conveyor station.
The offset should be less than ±1 mm (±0.04”):
2.
The DS Standalone must be positioned parallel to the rolls on the conveyor station:
This is crucial for the GuardCom functionality and it is important to make the rolls on
the conveyor station and on the ROEQ top roller parallel.
3.
The DS Standalone can be attached to the floor or it can be mounted directly on to the
chassis/frame of the conveyor station through holes in the back plate.
Refer to the user guide for the DS Standalone.
Offset
Centre of
ROEQ
DS Standalone
Centre of rolls on
conveyor station
Rotational
axis of roll
Front of
DS Standalone
