RogaDAQ2 NVH Analyzer & Recorder
Dear Customer!
Congratulations on the purchase of your RogaDAQ2 SC. This Product has been carefully designed and
engineered to provide you with a precise and reliable data acquisition instrument. Please read this
instruction manual before using the product, and keep it at hand for reference.
You’re ROGA-Instruments-Team
1. Introduction
1.1 System Requirements
PC with compatible OS and one available USB-connector (USB1.0, 1.1 or USB 2.0)
1.2 Included Parts
Following parts are included:
• 1 RogaDAQ2 2-Channel-DAQ
• 1 USB-cable
• 1 CD ROM
• 1 carrying case
1.3 Safety Information– read before use!
Caution: The unit is only suitable for low voltage measurements. Under no circumstance should
voltages (AC or DC) above 40 Volt peak be connected to any input or output. Please enable the IEPE
supply only while an IEPE compatible sensor is connected to that input, as other devices may be destroyed
by the IEPE voltage of up to 28V.
The IEPE supply may also cause interference if there is no sensor connected.
2. Getting started
2.1 Connecting hardware
2.1.1 PC connection:
Use the supplied USB-cable to connect the RogaDAQ2 to an available USB port on your PC.
2.1.2 Analog Input
Connect your signal or sensor to the analog inputs (in 1 and in 2) using the supplied BNC cable
RogaDAQ2
Rev. 1.6 - 09.2009
2 channel sound card version
