FR
138
TEST
FERMÉE
Voir chapitres 15 et 16.
TEST
TEST
Oui
Non
WD
GD
Non
APPRENDISAGE
DE LA COURSE
Ch. 11.2
APPRENDISAGE
DE LA COURSE
Ch. 11.2
Appuyer
TEST
PROG
$3 3
jusqu'à...
1 clic
1 clic
1 clic
1 clic
11.2
Procédure d'apprentissage :
AP P-
PH A5
AU to
PROG
x4 s
OUVERTURE OUVERTE
FERMETURE
FERMÉE
Oui
DÉBLOQUER
BLOQUER
2x360°
2x360°
45°
PH A5
AU to
• Appuyer sur la touche PROG pendant 4 s, sur l'écran s'affiche
$3 3
-.
• Débloquer la barrière.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8
. Faire deux tours complets de clé en sens anti-horaire.
BIONIK4
. Ouvrir la trappe de déverrouillage.
• La barrière s'ouvrir à 45°.
• Après quelques secondes sur l'écran apparaît
3+ $6
. La centrale lance une procédure de réglage. Au cours de cette phase, les
paramètres de fonctionnement du moteur sont calculés.
• Si le réglage du moteur est allé à bon port,
3+ $
clignote à l'écran.
• Pour rebloquer à nouveau.
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8.
Faire deux tours complets de clé en sens horaire.
BIONIK4
. Fermer la trappe de déverrouillage, et tourner la clé.
• À ce stade, la procédure d'apprentissage commence. Sur l'écran apparaît
$XWR
et la barrière démarre une manoeuvre
en ouverture à faible vitesse.
• Une fois atteinte la butée mécanique d'ouverture, la barrière s'arrête brièvement. Sur l'écran clignote
$XWR
.
• La barrière se referme jusqu'à atteindre la butée mécanique de fermeture.
Si la procédure d'apprentissage est terminée correctement, l'écran entre en modalité d'affichage commandes et sécurités.
Si l'écran affiche les messages suivants d'erreur, répéter la procédure d'apprentissage :
•
QR 3+
: procédure d'étalonnage échouée.
•
$3 3
.
(
: erreur d'apprentissage.
Pour des informations complémentaires, voir le chapitre 16 « Signalisation des alarmes et des anomalies ”.
Summary of Contents for CTRL
