PT
200
8
Teclas de função e display
PROG
UP
DOWN
TEST
TECLA
DESCRIÇÃO
UP
a
Parâmetro seguinte
DOWN
b
Parâmetro anterior
+
Aumento de 1 do valor do parâmetro
-
Diminuição de 1 do valor do parâmetro
PROG
Aprendizagem do curso
TEST
Ativação da modalidade TESTE
• Premir as teclas UP
c
e/ou DOWN
b
para visualizar o parâmetro a modificar.
• Com as teclas
+
e
-
alterar o valor do parâmetro. O valor começa a piscar.
• Mantendo premida a tecla
+
ou a tecla
-
, ativa-se o deslizamento rápido dos valores, permitindo uma variação mais
rápida.
• Para guardar o valor programado, aguardar alguns segundos, ou deslocar-se para um outro parâmetro com as teclas UP
a
ou DOWN
b
. O display pisca rapidamente para indicar a gravação da nova programação.
• A modificação dos valores somente é possível com o motor parado. A consulta aos parâmetros é sempre possível.
9
Ignição ou comissionamento
Alimentar a unidade de controlo.
No display aparece, por um tempo limitado, a versão do firmware da unidade de controlo.
Versão instalada r3.50.
Logo depois, o display exibe a modalidade de estado dos comandos e dispositivos de segurança. Ver capítulo 10.
Realize a regulação da instalação através da alteração dos parâmetros.
Em instalações de duas barreiras opostas, as regulações devem ser realizadas na unidade de controlo MASTER. Na unidade
de controlo SLAVE é possível alterar apenas os parâmetros
$
e
.
10
Modalidade de funcionamento do display
10.1
Modalidade de visualização dos parâmetros
PARÂMETRO
VALOR DO PARÂ-
METRO
Para as descrições detalhadas dos parâmetros, consulte o capítulo 12.
Summary of Contents for CTRL
