Roger Technology CTRL Instruction And Warnings For The Installer Download

Page: 89 / 292

Mechanical release

In the event of a fault or mains power loss, the barrier may be released and opened manually.

For further information, refer to the locking/release operation in the manual of the
BIONIK4, BIONIK4HP, BIONIK6, BIONIK8 automation system.

If the barrier is unlocked while the controller is powered, the message

6WRS

ﬂashes on the display until the barrier is locked again.

The ﬂashing light and the signal lights (if installed) illuminate if the boom is moved manually.
If a "ventouse" electric lock is installed, unlocking the barrier cuts off the power supply, making it possible to move the boom
manually.
The barrier resumes normal operation once the release system is locked again.

Initial testing

The testing must be performed by qualiﬁed technical personnel.
The installer is required to measure impact forces and select on the control unit the appropriate
speed and torque values to ensure that the motorised door or gate remains within the limits deﬁned
by the standards EN 12453 and EN 12445.

Make sure that the provisions in Chapter 1 "GENERIC WARNINGS are observed.

• Turn on the power supply.
• Perform travel acquisition.
• Set acceleration, speed and deceleration values. Check that the values are correct for the

installation type. The boom must approach the mechanical stop at low speed, and then press
gently against the stop to hold the boom in the closed position. Setting a value between

and

for parameter

ensures that the boom approaches and arrests against the stops slowly

without vibration. For booms up to 4 m in length, values between

and

are recommended

for parameters

and

. For longer booms, set a higher value.

NOTE

: for BIONIK8 barriers, pay special attention when setting parameter

. Avoid excessive

oscillation upon reaching the end stop when closing.ì

• Check that all connected controls are working correctly.
• Check that the release device functions correctly. The message

6W23

must ﬂash on the display.

•  Check if the impact forces are compliant with the EN 12453 and EN 12445 standards.
•  Check that the safety devices are activated correctly.
•  If installed, check the correct operation of the BreakAway

ACS/BA/60

detachable boom coupling

system.

• If the battery kit is installed, disconnect from mains and check that the batteries are working.
• Disconnect from mains power and disconnect the batteries (if used), then reconnect. With the

barrier stopped in an intermediate position, check that the manoeuvre is performed correctly.

• Check that the mechanical stops are set correctly. Repeat the travel acquisition procedure after

each adjustment.

• In the case of installations with two opposed barriers, request a manoeuvre and check that both

barriers function correctly.

• If a "ventouse" electric lock is used, check that when the boom is completely closed the lock

activates and the boom cannot be lifted from the ﬁxed end rest with integrated magnet.