Storing a simple user entry code (Example to open the gate).
(Assuming the engineer’s code is 0000, if you have changed it use your new 4
digit engineer’s password)
1) Key in
*0000*
(This enters programming using the engineers password)
2) Key in
5555##
(This sets the new entry code to 5555 or use a 4 digit code of
your choice)
3) Done
Using the keypad – Simple user entry code
(The enter button is *, and it is assuming you have changed the entry code to
5555 or if not use the actual code you have set)
1) Key in
5555**
(This enters your user entry code, and opens the gate)
Learning Procedure - Roger control box or standalone receiver.
(The keypad learns in the same way that your learn the gate remotes, refer to
the control box instructions)
After pressing
P1
on the radio card the led will flash slowly.
1) Then key in
5555**
(This enters your user entry code 5555** into the
receiver)
Troubleshooting
