ADL-2 User Manual.doc
2021-11-03
Page 5 of 12
Fig. 5. Internal part of lock
Door cylinder
ADL-2 lock is adapted to installation of typical door cylinder. Such cylinder enables emergency door
opening from the outside using metal key. The size of cylinder depends on door thickness and it must
be selected in such way that it would not protrude by more than 16mm over door surface on external
side and not more than 21-24mm on internal side. It is also possible to install thumbturn cylinder in
ADL-2 lock.
F
UNCTIONAL DESCRIPTION
In order to access the apartment the user must enter valid PIN using lock’s keypad. The PIN must be
started with ‘*’ (when pressed then keypad backlight is on) and finished with ‘#’. Alternatively, PIN
can be stored on proximity card by means of Roger MDM app and then the access can be granted by
card reading at the lock. In case of ADL-2-BLE the access can be also granted using smartphone with
Roger Mobile Key app (iOS, Android) installed.
Note: ADL-2 locks support only MFC-4 (Roger) proximity cards.
ADL-2 locks can be operated in Office mode. When the mode is enabled then the lock is permanently
opened (external handle is engaged) and door can be opened without PIN or any other identification
method.
It is possible to deactivate particular PIN by assigning it to the list of blocked PINs. This can be done
by means of PIN Master or Roger MDM app. Only single PIN8/12 can be activated in the lock. When
new PIN8/12 is entered then the previous one is automatically blocked.
