22
EN
22
8
11.5
Support and boom installation
1. Unlock the barrier (see chapter 21).
2. Based on the opening direction of the barrier (fig. 7), turn the linkage lever until reaching the stop on the mechanical limit switch (fig. 7), in the
position in which it is possible to install the boom horizontally.
3. Lock the barrier.
4. Open the boom support cover [
A
] by unscrewing the self-tapping screws TCC 4.2x19 [
B
] .
5. Loosen the screws [
E1
] and insert the boom support [
C
] on the drive shaft [
D
] making sure that there is a maximum distance of 1 mm between
the support and the barrier cabinet, as shown in the detailed view.
6. Fasten the support with the TCEI M8x35 screws [
E1
], [
E2
] and [
E3
] tightening them securely.
7. Fasten the rear cover with the provided self-tapping screws [
F
] TCC 4.2x19.
8. Unscrew the screws [
G
] TCC 4.2x13 and remove the cap [
H
].
9. Unscrew the screws [
I
] TCC 2.9x19. Remove the support [
L
], shock-resistant rubber [
M
] and the profile [
N
] at least 200 mm.
10. Insert the boom [
O
] in the support [
C
] and fasten it with the provided screws TCEI M8x20 [
P
] (complete with washers).
11. Reposition the profile [
N
], the shock-resistant rubber [
M
] and the plastic support [
L
] and fasten them with the screws [
I
] TCC 2.9x19.
12. Fasten the cap [
H
] with the screws [
G
] TCC 4.2x13.
13. Fasten the plastic support cover [
A
] with the self-tapping screws TCC 4.2x19 [
B
].
A
C
E2
E1
B
G
H
M
200
L
D
C
F
I
P
P
E3
E3
E3
N
O
1 mm
C
C
Summary of Contents for BI/004
Page 1: ......
