ME-2 and ME-2-D Metal Enclosures v1.0 Rev. B.doc
2016-10-08
Page
3
of
8
2.
I
NSTALLATION
ME-2 should be installed on a vertical part of construction in location protected against moisture
and dust, ensuring nominal operating conditions required for the enclosure and internal devices.
The 230VAC power supply cable must enter the enclosure through the dedicated cable bushing.
Protective Earth (yellow-green) cable should be connected to ground terminal.
3.
ME-2-D
SET
ME-2-D set includes ME-2 metal enclosure and following devices:
·
Buffer switch mode power supply unit PSBOC501235 (PSBOC 13.8/3.5A/OC)
·
Fuse block for power distribution LB5/AW (AWZ536)
These devices must be installed by your own according to fig. 2 and included manuals provided by
their manufacturer (Pulsar Sp.j.).
PSBOC501235 PSU is designed for uninterrupted supply and is not equipped with power supply
switch. PSU supply circuit must be equipped with adequate overload protection and enable easy
disconnection from the 230VAC mains without modifications of existing wiring. It is necessary to
instruct the end user on the method of disconnecting from the mains, e.g. by means of designated
fuse in switchboard. Electrical installation must be completed in accordance with valid regulations
and standards. 230VAC power supply cable must enter metal enclosure through dedicated bushing
and then connected to 230VAC L-N terminals. Protective Earth (yellow-green) cable should be
connected to ground terminal.
Table 2. ME-2-D specification
Parameter
Value
Supply voltage
230VAC (+/- 15%), 50Hz
PSU
Buffer power supply unit with battery and mains monitoring
PSU output voltage
13.8VDC
PSU output current
Max. 3.5A (including battery charging current)
Battery charging current
0.5A
Tamper contact
30VDC/0.5A
Power distribution
Fuse block for power distribution, 5 power outputs
protected independently with 0.5A or 1.0A fuses
Environmental conditions
-10C..+40C, relative humidity 10-90% (no condensation)
Dimensions (H x W x D)
403 x 326 x 130 mm
Weight
3.5 kg
Caution: The ME-2-D set should be installed by a qualified person with valid permits
and licenses for 230VAC mains and low-voltage installations.
Prior to installation and maintenance, it is necessary to make sure that 230VAC is
disconnected. It is forbidden to use this equipment without fully operational electric
shock protection circuit otherwise it may cause damage to device and/or electric
shock.
