RWL-1 Operating Manual.doc
2020-03-25
13/18
from the lock’s memory. Once option is set it can be cleared by
memory reset procedure only. The purpose of the option is to
prevent unauthorized person to read card numbers from the lock’s
memory. Default value: No.
Don't disturb knob switch
When option is set (Yes), rotating the knob switch located on the
internal escutcheon will disable access to the room by means of
cards. Each time door is opened using handle, knob switch returns
to off position. Default value: No (option off).
Wireless settings
Device MAC address
Factory set RWL-1 lock identification number.
Hub MAC address
The identification number of the wireless hub (e.g. RWH-1) to
which lock may connect.
Radio channels
Radio channels enabled to be used by lock. It is recommended to
allow all channels on the lock and restrict radio channels on the
hub. Default value: all channels available.
Network identifier
The identification number of the wireless network in which lock
operates (PAN ID). Each network working on the same radio
channel should be assigned with unique PAN ID. The range of
available values is 0-16. Optionally the parameter can be set to
AUTO. In such case the hub shall select PAN ID automatically.
Default value: AUTO.
Encryption key
Encryption key used for wireless communication. In case of
recommended empty field the key shall be defined and applied
automatically when the network is defined. Default value: Auto.
Notification time [s]
The parameter defines how often the lock shall wake from standby
mode and shall communicate with hub to confirm its availability in
the network. The shorter is the notification time the more often
communication is established and batteries are discharged quicker.
Default value: 60s.
Registration time [s]
The parameter defines the time necessary to read card at the lock
in order to add the lock to the network. If the time is exceeded
then lock adding procedure must be started from the beginning.
This parameter concerns network establishing procedure only.
Default value: 600s.
Network restore attempt time
[min.]
The parameter defines time between consecutive attempts to
restore wireless communication with the hub when it is broken due
to some reason. Default value: 30min.
Radio channel
The parameter indicates radio channel used by the lock. This
parameter is read-only and appears only if the lock is successfully
enrolled into the network.
Network ID
The parameter indicates network ID (PAN ID) in which lock
operates. This parameter is read-only and appears only if the lock
is successfully enrolled into the network.
Dynamic user list
The parameter enables dynamic user list. Users from the list can
be granted access when the communication with lock is lost.
Default value: Yes.
Dynamic user timeout [s]
The parameter specifies how long each card on dynamic user list is
stored and consequently can be granted access. The time is
counted from the latest use of the card. Default value: 3600.
