RWL-1 Operating Manual.doc
2020-03-25
4/18
Fig. 4. Electronic module inside external escutcheon
Internal part of RWL-1
The internal part of RWL-1 consists of escutcheon with handle and it is dedicated to installation at the
exit from controlled room. The escutcheon is equipped with knob switch (H) and detector to monitor
its status using cable with connector (I). The connector can be plugged into socket (K) at the mortise
lock. In
Online mode
the status of knob is reported to access controller with KNOB SWITCH input,
which can be further configured in VISO management software. In
Offline mode
the door can be
locked with the knob switch and then it cannot be opened from the outside using proximity card.
When the handle is twisted then the knob reverts to normal position. The internal escutcheon includes
also battery pack (J). In order to replace batteries unscrew two top bolts and pull the pack off. Wires
with plug (M) are connected to socket (E) at external escutcheon in order to supply it.
Fig. 5. Internal part of RWL-1
