RWL-1 Operating Manual.doc
2020-03-25
5/18
Mortise lock
The mortise lock includes servomechanism which can be controlled by electronic module located
inside external escutcheon. Two groups of wires with plugs come out of the mortise lock. The larger
plug (L) is used for connection with internal part of RWL-1 while the smaller plug (K) for connection
with external part of RWL-1.
The lock is equipped with latch (M), deadbolt (N) and release bolt (O). Once the door is closed, the
deadbolt is released automatically. Deadbolt status is reported to access controller (DEADBOLT input).
The door can be opened by internal handle, external handle or metal key. The deadbolt can be
controlled by external handle only if it is coupled by servomechanism controlled by electronic module.
External handle is coupled momentary whenever access is granted. When the RWL-1 is operated in
Office mode
then external handle is coupled permanently. Handle spacing i.e. distance from handle to
cylinder in the mortise lock equals to 72mm.
Fig. 6. Mortise lock
Door cylinder
RWL-1 lock is adapted to door cylinder installation. Such cylinder enables emergency door opening
from the outside using metal key. The size of cylinder depends on door thickness and it must be
selected in such way that it would not protrude by more than 12mm over door surface. The door
cylinder 26/10 is included with RWL-1 lock and it can be used in door with 38mm to 55mm thickness.
F
UNCTIONAL DESCRIPTION
The RWL-1 can be used as autonomous access control point, where the access is granted based on
the data stored in the lock’s memory, or as a networked access point operating in the on-line access
