RWL-1-SL Operating Manual.doc
2021-12-20
6/13
programming computer with the RogerVDM application and connected to the lock through RUD-1
communication interface. If the lock is designated to operate with list of 50 users, each equipped with
Main card
and
Backup card
, it can be programmed manually without computer. In this scenario, two
programming cards, called ADD card and DEL card, are used to program the unit.
Note: Due to the small size of the proximity keyfobs, they may be incorrectly detected by the built-in
proximity sensor. In the RWL series locks, it is recommended to use full-size ISO proximity cards.
Proximity cards
The lock is equipped with a card reader which supports MIFARE® cards. Factory configured device
reads card serial number (CSN -
Chip Serial Number
), but using RogerVDM software it can be
configured to use programmable card number (PCN –
Programmable Card Number
) stored in the
encrypted memory of the MIFARE card.
Card number
The card number which RWL-1-SL lock reads from the card and returns to the access controller is
called RCN (
Returned Card Number
). In general, the RCN can be composed of two sections:
·
CSN section
·
PCN section
The CSN section is a part of the RCN card number taken from the card serial number (CSN). The
serial number is programmed by card manufacturer.
The PCN section is a part of the RCN card number taken from the card’s programmable memory. The
programmable number can be encrypted with own key in order to enable protection against card
copying.
Due to relatively easy copying of the card serial numbers (CSN), it is recommended to configure the
lock for operation with programmable card numbers (PCN).
Standalone Access Control
The lock grants access for cards stored in its memory. Up to 100 cards can be defined and stored in
lock’s memory. Each card can be authorised for momentary door opening (option:
Normal access
)
and/or to open the door for unlimited time (option:
Office access
). If the card is authorized for
Normal
access
then it opens the lock for the time specified by the parameter
Lock pulse
. If the card is
authorized for
Office mode
then it can open the lock for unlimited time. When lock is switched to
Office mode
door can be open without use of a card. If the card is authorised for
Normal access
and
Office mode
then in order to get normal access it must be used once while in order to activate
Office
mode
it must be used twice.
The access to a room from the outside can be blocked with knob switch located at the internal
escutcheon. The functioning of knob can be disabled with the parameter
Don't disturb knob switch.
Backup cards
Up to 100 cards can be defined and stored in lock’s memory. Each card can belong to individual user.
Optionally the lock can operate with 50 users only. In such a case each user can have two cards:
Main
card
and
Backup card
. Both cards have the same authorizations and the enrolment of
Backup card
is
optional. Factory new lock is configured to operate with 50 users. This mode is also used when lock’s
default settings are restored. Switching to 100 users mode can be done only by means of RogerVDM
software. The main benefit of
Backup cards
is to enable selective removing of
Main cards
from the
lock’s memory even if such
Main cards
are not physically available (e.g. lost or damaged). Therefore
it is recommended to mark and store
Backup cards
in designated place for future use.
Note:
Backup card
is assigned with same authorizations as accompanying
Main card
and can be used
in the same way as the
Main card
.
