RWL-2 Operating Manual.doc
2018-06-29
5/17
F
UNCTIONAL DESCRIPTION
The RWL-2 can be used as autonomous access control point, where the access is granted based on
the data stored in the lock’s memory, or as a networked access point operating in the on-line access
control system. In the
Online mode
access is controlled by the external controller. Transmission
between the lock and controller is wireless and requires intermediary RWH-1 hub. Regardless of the
selected working mode (online or offline) the lock requires configuration which can be done from the
programming computer with the RogerVDM application and connected to the lock through RUD-1
communication interface. If the lock is designated to operate in
Offline mode
with list of 50 users,
each equipped with
Main card
and
Backup card
, it can be programmed manually without computer. In
this scenario, two programming cards, called ADD card and DEL card, are used to program the unit.
Proximity cards
The lock is equipped with a card reader which supports MIFARE® Ultralight/Classic/DESFire/Plus
cards. Factory configured device reads card serial number (CSN -
Chip Serial Number
), but using
RogerVDM software it can be configured to use programmable card number (PCN –
Programmable
Card Number
) stored in the encrypted memory of the MIFARE card.
Card number
The card number which RWL-2 lock reads from the card and returns to the access controller is called
RCN (
Returned Card Number
). In general, the RCN can be composed of two sections:
·
CSN section
·
PCN section
The CSN section is a part of the RCN card number taken from the card serial number (CSN). The
serial number is programmed by card manufacturer.
The PCN section is a part of the RCN card number taken from the card’s programmable memory. The
programmable number can be encrypted with own key in order to enable protection against card
copying.
Using RogerVDM program, installer can define the method used to read card number. It is possible to
operate solely with CSN or PCN number, or combination of both (CSN+PCN). By default, lock utilizes
CSN number.
Note: Due to relatively easy copying of the card serial number (CSN), it is recommended to configure
the lock for operation with programmable card number (PCN). If so, cards have to be programmed in
the way which corresponds with lock’s card number configuration.
Offline mode
In the
Offline mode
, the lock grants access for cards stored in its memory. The lock can operate
permanently in
Offline mode
or enter this mode temporary, when operating in
Online mode
but
wireless connection with controller is lost.
Up to 100 cards can be defined and stored in lock’s memory. Each card can be authorised for
momentary door opening (option:
Normal access
) and/or to open the door for unlimited time (option:
Office access
). If the card is authorized for
Normal access
then it opens the lock for the time specified
by the parameter
Lock pulse
. If the card is authorized for
Office mode
then it can open the lock for
unlimited time. When lock is switched to
Office mode
door can be open without use of a card. If the
card is authorised for
Normal access
and
Office mode
then in order to get access it shall be used once
while in order to activate
Office mode
it shall be used twice.
Backup cards
Up to 100 cards can be defined and stored in lock’s memory. Each card can belong to individual user.
Optionally the lock can operate with 50 users only. In such a case each user can have two cards:
Main
card
and
Backup card
. Both cards have the same authorizations. Factory new lock is configured to
