Security Locks SL2000F and SL2000F-VP EN
2020-05-06
Page
7
of
12
3 :
USER codes are 8 digits long
C10:
Defines the length of the
MASTER
and
INSTALLER
codes, enter 0-3, (default: 1).
0 :
Both codes are 4 digits long
1 :
Both codes are 6 digits long
2 :
Both codes are 8 digits long
3 :
Both codes are 10 digits long
If an illegal operation occur during Memory Reset the device will signal an error (long beep) and will return to
the beginning of the programming so you can start to enter the C1-C10 digits once again. The Memory Reset
procedure automatically comes to an end when the last (C10) digit is entered. The device stores the
configuration as well as all codes in a nonvolatile memory which can be reprogrammed whenever required.
After the Memory Reset procedure comes to an end all codes are set to factory default values (see section
below: Default Codes).
Example:
The following digits C1-C10 were entered during the Memory Reset procedure: [0][1][0][2][3][3][1][0][2][3]
This sequence sets the following options:
Delay before Door Lock open: 01 second
Door Lock open time: 02 seconds
Time to close the door: 33 seconds
Reprogramming of the MASTER code: disabled
Reprogramming of the INSTALLER code: enabled
Option 1 (Timed Lock-out): off
Option 2 (Disable USER Codes When in Armed Mode): off
USER codes length: 6 digits
MASTER and INSTALLER codes length: 10 digits
Default Codes
After the Memory Reset is accomplished Sl2000 restores following codes:
MASTER Code
All digits are “1” (1111…), the length of the code depends on the
C10
parameter entered later during Memory
Reset procedure.
INSTALLER Code
All digits are “2” (2222…), the length of the code depends on the
C10
parameter entered later during Memory
Reset procedure.
USER Code no 01
All digits are “3” (3333…), the length of the code depends on the
C9
parameter entered later during Memory
Reset procedure.
USER Code 02..55
All USER codes no 02 -55 are blank (they doesn’t exist).
Installation
The SL2000 code lock should be mounted near the supervised door on a vertical piece of supporting
structure.
The SL2000F can be installed in indoor location only.
The SL2000F-VP can be installed either indoor or outdoor location.
Assure that the surface beneath of the controller’s rear panel is flat and smooth.
Disconnect power supply before making any electrical connections.
Once installed and electrically connected, the unit has to be properly programmed.