XM-2DR Operating Manual.doc
Page
5
of
7
module contour (by at least 5mm at each side – see fig. 3). The installation of XM-2DR module
must be executed in accordance with valid safety rules.
Fig. 3 The arrangement of XM-2DR-BRD mounting holes
3.
C
ONFIGURATION
3.1 Module address
The configuration of XM-2DR expansion module is performed by means of jumpers in accordance
with table 4.
Table 4. Configuration jumpers
Jumper
Function
JP1
Address jumper „1”
JP2
Address jumper „2”
JP3
Address jumper „4”
JP4
Address jumper „8”
JP5
Unused
JP6
Unused
JP7
Selection of operation mode: Standalone/Normal
FDM
Firmware upgrade
