XM-2DR Operating Manual.doc
Page
6
of
7
Note: Every time a jumper is put or removed it is necessary to restart the module in order to make
new settings effective. The restart can be done by means of RESET button or power supply switch
off and on.
The address of XM-2DR can be programmed by means of jumpers based on their values e.g.
jumpers on pins JP1 and JP3 signify the address ID=5 (1+4 = 5) while jumpers on all JP1…JP4 pins
signify ID=15 (1+2+4+8 = 15).
JP7 pins can be used for selection of operation mode. If the jumper is on JP7 then XM-2DR
operates in standalone mode and then its relay outputs can be activated by electric signal at
corresponding inputs i.e. IN1 -> REL1 and IN2 -> REL2. If there is no jumper on JP7 pins then XM-
2DR operates in normal mode and control of its outputs and inputs is performed by controller by
means of RACS Clock & Data protocol.
Note: In case of network operating mode i.e. communication with PR series controller, it is
necessary to set XM-2DR address ID=5.
3.2 Firmware update
Roger devices are always delivered with the latest version of firmware but it can be updated by
customer. The latest version of firmware, which might offer new functionalities and/or eliminate
errors is available at
. New firmware can be uploaded to XM-2DR by means of
computer z with RogerISP software (ver. 5 or newer) and it requires communication interface
device e.g. RUD-1 connected to USB port of the computer.
Firmware update procedure
·
Place jumper on FDM pins
·
Connect XM-2DR to RUD-1 in accordance with table 5
·
Reset the device (use RESET button or switch power supply off/on)
·
Start RogerISP software and select communication port from the list
·
In Firmware window select firmware *.hex file
·
Click Program button
·
After firmware upload, remove jumper from FDM pins and reset the device (use RESET button
or switch power supply off/on)
·
Disconnect XM-2DR from RUD-1
Table 5. Connection of XM-2DR and RUD-1
XM-2DR terminal
RUD-1 terminal
+12V
1
GND
2
IO1/CLK
5
IO2/DTA
6
4.
O
RDERING INFORMATION
Product
Description
XM-2DR
Input/output addressable extension module with enclosure for installation on
DIN 35mm rail
XM-2DR-BRD
Input/output addressable extension module as electronic module without
enclosure
