25.
Provide all the information shown on the left-hand label in Figure 1. Be sure to provide all information of
possible hazards related to a given sample. If a noteworthy situation exists, all information shall be clearly
marked on the sample bottle label.
Tightly close the bottle and attach the information label on the side of the bottle. Place the labeled bottle
in the mailer. Attach the shipping label (right-hand label in Figure 2) to the outside of the mailer and place
it in the mail.
Figure 1. Lubricant Test Labels.
4.6
Lubricant Filter
The lubricant filter, shown below, is a spin on full-flow type, having a quality, high-efficiency element. The
lubricant filter’s purpose is to protect the close tolerances of the compressor and its bearings from
damage from foreign material and capture particulate in the lubricant stream to prolong the life of the
separator elements.
Figure 2. Spin-On Oil Filter.
4.6.1
Lubricant Filter Change Intervals
Lubricant filter elements should be changed every 1,000 hours.
Summary of Contents for KI Series
