background image

Installation 
Instructions

Arq 

by Rogerseller

Wall Mixer 

Specifications

It is a requirement of State Plumbing Codes that licensed plumbers carry out all tapware installations.  
All installations should comply with the relevant requirements of AS/NZS 3500 and local plumbing codes.

Pressure: 
[1] Maximum Hydrostatic Pressure: 1000kpa. This pressure may be exceeded only under test conditions as per AS/NZS 
3500. Where hydrostatic pressure exceeds the maximum stated above, pressure-limiting valves should be installed. 
[2] Recommended Maximum Hydrostatic Pressure: 500kpa (AS/NZS 3500). [3] Recommended Minimum Hydrostatic 
Pressure: 150kpa

Temperature: 
Maximum Water Temperature: 80° C. For optimum performance, hot and cold inlet water pressure should be equal.

Care and Maintenance

[1] Product should be inspected for surface damage prior to installation. [2] Cleaning and handling of all finishes must be 
performed carefully. [3] Clean products using a soft cloth with warm soapy water only. [4] Never use harsh detergents or 
abrasive cleaners as these will damage the product. [5] Water marks can be removed from Matt Finishes with an application 
of a carnauba wax based non-abrasive polish on a microfibre cloth. [6] Do not use undue pressure when cleaning and 
wipe in one direction only. [7] Contact with harsh chemicals such as hair dye, hair bleach etc with result in damage to the 
finish. [8] Tapware should never be installed using acetone silicones. [9] Avoid the use of wax based furniture creams as 
this can result in a build up of deposits which will detract from the appearance. [10] Rose Copper: A protective lacquer has 
been applied to this finish. This is required to maintain the stability of this finish and will be damaged if the above care and 
cleaning instructions are not followed. [11] Damage to finishes arising from improper installation or post installation use or 
failure to observe the above care and cleaning instructions will void all warranty agreements.

Warranty

Rogerseller tapware, bathroom fittings and sanitary ware are covered by a five (5) year warranty from date of purchase. 
For full terms and conditions please refer to rogerseller.com.au

rogerseller.com.au

Rogerseller Showrooms —

Melbourne

 

 173-177 Barkly Avenue 
Burnley VIC 3121  
P  03 9429 8888 

Sydney

 

18 Danks Street 
Waterloo NSW 2017 
 P 02 8396 8700  

Brisbane 

 

74–76 McLachlan Street 
 Fortitude Valley QLD 4006 
 P 07 3251 4333

Reviews: