Remote Control Commands
R&S
®
NGP800
98
User Manual 5601.5610.02 ─ 04
*SRE
<Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents>
Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range:
0 to 255
*STB?
Status byte query
Reads the contents of the status byte in decimal form.
Usage:
Query only
*TST?
Self-test query
Initiates self-tests of the instrument and returns an error code.
Return values:
<ErrorCode>
integer > 0 (in decimal format)
An error occurred.
0
No errors occurred.
Usage:
Query only
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
).
Usage:
Event
*SAV
<Number>
Save
Stores the current instrument settings under the specified number in an internal mem-
ory. The settings can be recalled using the command
with the associated num-
ber.
Common Setting Commands
www.allice.de
Allice Messtechnik GmbH
